Use this guide to remove and replace the rear cameras in the iPhone 11. The rear camera assembly consists of one wide-angle module and one ultra-wide angle module. Both are replaced together, as a single unit.
'''Note''': This guide instructs you to completely detach the display cables and remove the display assembly in order to better access the rear cameras—however, it's possible to remove and replace the rear cameras with the display cables still connected. Advanced readers may skip disconnecting the display in order to save time, as long as the display is properly supported and the display cables are not damaged.
Remove the pentalobe screws
Mark your opening picks
Tape over any cracks
Anti-Clamp instructions
Heat the lower edge of the phone
Lift the display slightly
Separate the screen adhesive
Screen information
Remove the suction cup
Open the iPhone
Unscrew the battery connector cover
Remove the battery connector cover
Disconnect the battery
Unscrew the logic board cover screws
Remove the logic board cover bracket
Disconnect the display
Disconnect the front sensors
Remove the display assembly
Unscrew the rear camera cover
Remove the camera cover
Disconnect the cameras
Loosen the camera assembly
Compare your new replacement part to the original part—you may need to transfer remaining components or remove adhesive backings from the new part before installing.
To reassemble your device, follow the above steps in reverse order.
Take your e-waste to an [[E-Waste|R2 or e-Stewards certified recycler|new_window=true]].
Repair didn’t go as planned? Try some [[Troubleshooting Problems After a Repair|basic troubleshooting]], or ask our [link|https://www.ifixit.com/Answers/Device/iPhone%2011|iPhone 11 Answers community] for help.