iPhone 14 Rear-Facing Cameras Replacement

moderate45 - 55 minutes

Use this guide to replace the rear-facing cameras in your iPhone 14.

This guide was created using the A2882 (international) model. If you're fixing a different iPhone 14 model, there may be some visual discrepancies, but the procedure should be the same.

Note: On iOS 18 and newer, you can calibrate new, genuine camera modules using Apple's [link|https://support.apple.com/en-us/120579|Repair Assistant|new_window=true].

You’ll need replacement adhesive to reattach the screen when reassembling the device. Your device will function normally, but will most likely lose its IP (Ingress Protection) rating.

Remove the pentalobe screws

Mark your opening picks

Tape over any cracks

Heat the bottom edge

Insert an opening pick

Heat the left edge

Slice the left edge adhesive

Rear glass information

Heat the right edge

Slice the right edge adhesive

Heat the top edge

Slice the top edge adhesive

Open the iPhone

Unfasten the battery connector cover screws

Remove the battery connector cover

Disconnect the battery

Unfasten the charging coil connector cover screw

Remove the charging coil connector bracket

Disconnect the charging coil

Remove the rear glass assembly

Disconnect the rear-facing camera assembly

Remove the rear-facing camera assembly screws

Pry up the rear-facing camera assembly

Remove the rear-facing camera assembly


If possible, turn on your device and test your repair before installing new adhesive and resealing.

Compare your new replacement part to the original part—you may need to transfer remaining components or remove adhesive backings from the new part before installing.

To reassemble your device, follow these instructions in reverse order.

After your repair, depending on the replacement part, you may be able to [link|https://support.apple.com/en-us/120579|calibrate it using Apple's Repair Assistant|new_window=true], available as of iOS 18. Update your device, navigate to Settings General ***→***About Parts & Service History, tap Restart & Finish Repair, and follow the onscreen prompts.

Take your e-waste to an [[E-Waste|R2 or e-Stewards certified recycler|new_window=true]].

Repair didn’t go as planned? Try some [[Troubleshooting Problems After a Repair|basic troubleshooting]], or ask our [link|https://www.ifixit.com/Answers/Device/iPhone%2014|Answers community] for help.